our products

D&Q Mining is a high-tech company integrating R&D, production and sales. It provides mature products and solutions such as crushers, sand making, milling equipment, mobile crushing stations, etc., for aggregate, mining and waste recycling.

Horizontal Surfaces Installation

HORIZONTAL SURFACES EXTERIOR STONE PAVING

HORIZONTAL SURFACES 1.0 INTRODUCTION most moderate and any heavy 1.1 Installation Methods. Stone paving can be installed by several methods. Consideration should be given to the various features of each method in making a selection for a specific installation. See illustrations of installation examples at the close of this section.

More

Horizontal Surfaces Rosa Mosaic

Ó 2011 Marble Institute of America (version 7.2) Horizontal Surfaces/General Notes " Page 14-1 HORIZONTAL SURFACES 1.0 INTRODUCTION 1.1 Installation Methods. Stone paving can be installed by several methods. Consideration should be given to the various features of each method in making a selection for a specific installation.

More

Stucco No-Nos: Never Apply to Flat and Horizontal Surfaces

Jun 26, 2015 When you apply stucco on flat or horizontal surfaces, eventually the stucco or EIFS will start to break down with changing seasons and temperatures, and before you know it more and more water will start to accumulate. If the water is not deflected, the water will eventually damage the wood, leading to mold and rot and dangerous toxins.

More

Because We’ve Always Done It That Way: EIFS Installation

Apr 01, 2017 And, when the horizontal surface of a given building exceeds 18 to 24 inches in width, it transforms into another structure known as a roof. The EIFS industry has gone to great lengths in making the edicts of EIFS installation. Trust that they are well thought out, are proven successful and are not intended to impede the applicator.

More

SECTION 6 — Preparing for Horizontal Siding

CertainTeed Vinyl Siding Installation Guide 28 SECTION 6 — Preparing for Horizontal Siding Preparing Wall Surfaces Sheathings In new construction, apply sheathing first, then nail accessories over it. The application method you choose determines

More

Details for Installing Exterior Trim on buildings

Avoid wide horizontal wood surfaces exposed to water. Slope for drainage or cap with metal flashing. Cut drip groove under edge to shed water. Slope top edges of exterior railings and horizontal trim boards, such as water tables, to shed water. Avoid exposed end-grain facing upward in vertical trim boards. Heavily prime all end grain and

More

Stucco Installation, Procedures and Guidelines

sq. ft. on vertical surfaces and 100 sq. ft. on horizontal surfaces. The distance between control joints shall not exceed 18 feet, in either direction, or exceed length- to-width ratio of 2-1/2 to 1.

More

CCW MiraDRAIN BuildSite

vertical and horizontal surfaces face the soil. 2. Utilize the installation procedures and attachment method appropriate for the type of substrate. 3. Overlap the fabric of the vertical panel onto the horizontal panel at the transition point. 4. If the panels require

More

HardieShingle Installation Inst HZ10

1) Install a 1-1/4 in starter strip, then install a 8-1/4 in wide HardiePlank® lap siding starter course. 2) Place first panel so that panel end centers over stud. Trim panel as needed. Butt the cut end into trim as shown (figs 22 & 24). When installing over a band board or any horizontal surface, leave

More

Horizontal Left Furnace, Evap. Coil & Condenser Install

Mar 29, 2018 We installed a full system in a crawlspace Residential hvac heating and air

More

Self-Adhering Sheet Waterproofing Membrane

On a horizontal deck do not apply membrane when forms are in place, unless the forms are vented. Concrete should be allowed to cure for a minimum of 7 days before application of the sheet membrane. from an improper surface. Upon installation of a second layer of TW-60, the first layer of TW-60 is recognized as part of the assembly substrate

More

BITUTHENE® 4000 System (US version) Resource GCP

Feb 05, 2021 All horizontal surfaces to receive BITUTHENE® 4000 membranes should be sloped to drain at least 1/8 in./ft. (11 mm/m). When a minimum slope of 1/8 in. /ft. (11 mm/m) cannot be achieved, two layers of BITUTHENE® 4000 membranes or 80-mils of BITUTHENE® Deck Prep surface treatment and one layer of BITUTHENE® 4000 membranes maybe an option.

More

Hardie Reveal Panel Installation Instructions

horizontal surface Flashing below trim rests on solid surface. Roof sheathing Drip edge Blocking Ledger J-Channel Sofit Reveal Panel Sub-fascia Fascia Code-approved weather resistive barrier laps over the step lashing Exterior sheathing Rainscreen furring (3/4 in thick) Vent screen 3/4 in min gap (do not caulk) Drainage lashing trim Optional

More

This is the Correct (and Incorrect) Way to Install an

Jan 12, 2021 Type of Equipment Used. The main reason there is so much debate is because electricians rely on the type of equipment that will be plugged in to determine the orientation of the electrical outlet.. For instance, clothes washers, refrigerators and window air conditioners most commonly have cords with immediate-turn plugs, and so the logical way to install the outlet would be to orient it

More

SikaTop-122 Plus is a trowel-grade mortar for horizontal

SikaTop®-122 Plus is a two-component, polymer-modified, portland cement based, fast-setting, trowel-grade mortar. It is a high-performance repair mortar for horizontal and vertical surfaces and offers the additional benefit of Sika FerroGard® 901, a penetrating corrosion inhibitor.

More

EIFS Problems and Solutions Building Science Corp.

Jul 11, 2007 This map defines four rain exposure regions based on annual rainfall on a horizontal surface: extreme, high, moderate and low. The rain that must be controlled by walls is rain on a vertical surface. The amount of rain actually deposited on a wall can vary dramatically (by a factor of ten) in a given climate zone depending on height, exposure

More

WATERPROOFING SYSTEMS Henry

AQUA-BLOC® COLD-APPLIED MEMBRANES: GOES ON ELASTIC AND STAYS ELASTIC APPLICATIONS: Aqua-Bloc® is an elastomeric, asphalt membrane available in four grades for application to horizontal and vertical surfaces, above or below grade: Waterproofing Foundations • Tunnels • Planters • Retaining Walls • Elevator Pits

More

Horizontal Environmental Well Design and Installation

Horizontal Environmental Well Design and Installation PREFACE Horizontal environmental wells have emerged as one of the robust and proven remediation technologies of the 21st century. Over the past fifteen years, hundreds of horizontal remediation wells have been installed in every conceivable geologic formation.

More

SECTION 6 — Preparing for Horizontal Siding

CertainTeed Vinyl Siding Installation Guide 28 SECTION 6 — Preparing for Horizontal Siding Preparing Wall Surfaces Sheathings In new construction, apply sheathing first, then nail accessories over it. The application method you choose determines

More

XPANDED METAL LATH INSTALLATION FOR THE

expanded metal lath installation for the application of portland cement stucco. The secondpart, which will cover “sins” five through eight, will be published in the January 1997 issue of Construction Dimensions. zontal semi-horizontal surfaces as being something other than walls. That is to

More

Horizontal Environmental Well Design and Installation

Horizontal Environmental Well Design and Installation PREFACE Horizontal environmental wells have emerged as one of the robust and proven remediation technologies of the 21st century. Over the past fifteen years, hundreds of horizontal remediation wells have been installed in every conceivable geologic formation.

More

Should You Align Backsplash Wall Tile Vertical or Horizontal?

Nov 06, 2018 While horizontal and vertical installations are popular, why restrict yourself? Ice Bevel Herringbone tiles are laid diagonally in an intricate pattern. Better still, they are pre-assembled on a mesh backing so a perfectly spaced installation of these glossy white tiles is a breeze. Metallic Gray Subway. Featured: Metallic Gray Subway Tile 3x6

More

CCW MiraDRAIN BuildSite

vertical and horizontal surfaces face the soil. 2. Utilize the installation procedures and attachment method appropriate for the type of substrate. 3. Overlap the fabric of the vertical panel onto the horizontal panel at the transition point. 4. If the panels require

More

Natural Stone Industry Glossary M S International Inc.

A joint, normally horizontal, between stones that is filled with sealant or mortar. Convex or arched shape of a horizontal surface. A method of installation where tile, granite, marble, or other stones are set into mortar and then finished in place.

More

Historic Masonry Restoration Best Practices Masonry Magazine

Aug 29, 2019 Protect Horizontal Surfaces . Assuming the roof and its details have been evaluated and are watertight, the first and most important repair should be to protect the horizontal surfaces of the facade, including parapets, cornices, belt courses, balconies, window sills, and any other projections. There are several options that vary in cost and

More

WATERPROOFING SYSTEMS Henry

AQUA-BLOC® COLD-APPLIED MEMBRANES: GOES ON ELASTIC AND STAYS ELASTIC APPLICATIONS: Aqua-Bloc® is an elastomeric, asphalt membrane available in four grades for application to horizontal and vertical surfaces, above or below grade: Waterproofing Foundations • Tunnels • Planters • Retaining Walls • Elevator Pits

More

SikaTop-122 Plus is a trowel-grade mortar for horizontal

SikaTop®-122 Plus is a two-component, polymer-modified, portland cement based, fast-setting, trowel-grade mortar. It is a high-performance repair mortar for horizontal and vertical surfaces and offers the additional benefit of Sika FerroGard® 901, a penetrating corrosion inhibitor.

More

Rebalancing Aircraft Control Surfaces Airplane Assembly

The primary assembly of a type certificated aircraft includes putting together the major components, such as the fuselage, empennage, wing sections, nacelles, landing gear, and installing the powerplant. Control surface must rebalance after repairs done on control surface. Checking the balance of the control surfaces after aircraft repainted.

More

The Horizontal Directional Drilling Process

Surface Monitoring The pilot hole path may also be tracked using a surface monitoring system. Surface monitoring systems determine the location of the probe downhole by taking measurements from a grid or point on the surface. An example of this is the TruTracker System. This system uses a surface coil of known location to induce a magnetic field.

More

STEEL SIDING INSTALLATION MANUAL Klauer

Uneven and/or out-of-plum surfaces can create waves or oil-canning as well as irregular shadow patterns in siding panels. remoVe downspouts / tie Back shruBs Remove downspouts and other items that would interfere with installation of new siding. Tie back shrubbery and trees from the base of the building to avoid damage to the landscaping.

More

VERTICAL SURFACES 1.2.1 Restraint and relief are

1.3.10 Exterior Vertical Surfaces. When adhesive installation methods are used for exterior vertical surfaces, the stone shall be back buttered to achieve, as close as practical, 100% adhesive contact between the stone and the backup. Remove freshly installed tiles periodically during installation to

More

2019 INSTALLATION GUIDE Trex

6 Trerxet1x-.8m1e TREX TRANSCEND®, TREX ENHANCE®, AND TREX SELECT® CARE AND CLEANING GUIDE All exterior building materials require cleaning. Generally, soap and water is all that is required to clean Transcend,

More